The dashboard is fabricated from 1/8" thick 5052 aluminum with a grained and anodized finish.  Gauges are AutoMeter electric types.   The dashboard wiring incorporates 2 pigtails that terminate in circular MIL connectors.  These connectors plug into bulkhead fittings in the rear wall of the front plenum.  This feature allows the dashboard to be removed complete with all gauges and wiring intact within about 15 minutes.  All original wires have been replaced with high quality wire of thicker gauge.  All switches (except window) have been converted to metal toggle units in the dash. Also in these views you can see the Tilton pedals, roll bar cross bracing at the rear bulkhead and on the floor, and the 5-point harness that penetrate through the original seats.